<font face="arial" size="4">Thanks everyone for the feedback on my question!<br><br>Todd<br><br>On Friday, October 1, 2010 9:32am, "Larry Crutcher" &lt;larry@starlightsolar.com&gt; said:<br><br>&gt; Todd,<br>&gt; <br>&gt; The shunt is only providing a mV DC signal. In our showroom we have a<br>&gt; working display wall of charge controllers and battery monitors (Blue<br>&gt; Sky, Trimetric, Morningstar, analog meters) with a single shunt to a<br>&gt; single battery. Works well for us. More than likely there is isolation<br>&gt; before the AD converter so I would not expect any problems with any<br>&gt; monitor.<br>&gt; <br>&gt; Prescaler may be a different story although I suspect it will work. It<br>&gt; is just converting a high voltage reference to a low one that the<br>&gt; battery monitor can accept. If there was an issue I would try a small<br>&gt; DC-DC device at the prescaler outputs going to each monitor.<br>&gt; <br>&gt; Larry Crutcher<br>&gt; Starlight Solar Power Systems<br>&gt; <br>&gt; On Oct 1, 2010, at 2:22 AM, Todd Cory wrote:<br>&gt; <br>&gt; &gt; Has anyone ever paralleled two amp hour meters on one shunt? How<br>&gt; &gt; about paralleling two e-meters on a single shunt and a single<br>&gt; &gt; prescaler?<br>&gt; &gt;<br>&gt; &gt; Todd<br>&gt; <br>&gt; _______________________________________________<br>&gt; List sponsored by Home Power magazine<br>&gt; <br>&gt; List Address: RE-wrenches@lists.re-wrenches.org<br>&gt; <br>&gt; Options &amp; settings:<br>&gt; http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org<br>&gt; <br>&gt; List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org<br>&gt; <br>&gt; List rules &amp; etiquette:<br>&gt; www.re-wrenches.org/etiquette.htm<br>&gt; <br>&gt; Check out participant bios:<br>&gt; www.members.re-wrenches.org<br>&gt; <br>&gt; <br></font><br><br><br>Sent from Finest Planet WebMail.<br>