<div dir="ltr"><div class="gmail_quote gmail_quote_container"><div>A lot of inverters (and other monitoring equipment as well) will only connect to a 2.4GHz wifi.  And more and more ISP's are providing routers that default to 5Ghz, or a mesh network.  If it's my own, I go in and turn off the 5Ghz (or at least add a 2.4Ghz) usually as 5Ghz is actually worse performance than 2.4Ghz for ISP's under about 200Mbps speed, in my opinion.  </div><div><br></div><div>But what I think is best practice for installs, and what I've tried to start doing, is add a 2.4Ghz router specifically for IoT things, like inverters. That way, when the customer gets a new ISP with a new ISP provided router, all you have to do is reconnect the IoT router to the ISP provided router (either with a hardwire cable, or programming the IoT router to rebroadcast the new ISP wifi).  Instead of having to go through possibly dozens of different IoT devices and reprogram them all to a new wifi SSID and password.  If you do this, you should probably put a label on the IoT router so the customer doesn't throw it away though... I've had them do that when they clean up their office, they don't know what some piece of equipment is, and throw it out.  Had many of them do that for the ethernet over powerline adaptors for the earlier egauge units, then call me up to ask why their monitoring didn't work any more -- and being an obsolete adaptor, you couldn't even just buy a replacement.</div><div><br></div><div>Z</div></div><div><br clear="all"></div><br><span class="gmail_signature_prefix">-- </span><br><div dir="ltr" class="gmail_signature"><div dir="ltr"><div><div dir="ltr">Zeke Yewdall<div>PV Engineer</div><div>NABCEP #031508-89</div><div><a href="mailto:zeke@darkforestsolar.com" target="_blank">zeke@darkforestsolar.com</a></div><div>303-523-3592</div></div></div></div></div></div>