Try this, Carl~<br><br>Strip about 1.5" off the end of your skinny stranded wire then fold it in thirds before <br>inserting it into the compression lug. It's still only one wire in case anyone should ask,<br>but your inspector may balk. Try it and see as this would depend on the inspector's <br>

particular mindset. <br><br>If you get failed, I would suggest copper split bolts to splice your skinny wires onto<br>short bits of fatter wire. This solution is more clunky, more expensive, and a wire <br>splice is always more risky than an uncut wire.<br>

<br clear="all">Jolliness,<br><br>Mick Abraham, Proprietor<br><a href="http://www.abrahamsolar.com">www.abrahamsolar.com</a><br><br>Voice: 970-731-4675<br>
<br><br><div class="gmail_quote">On Wed, Feb 9, 2011 at 5:23 PM, Carl Adams <span dir="ltr"><<a href="mailto:swingjunkie@gmail.com">swingjunkie@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;">

Wrenches,<br>
<br>
We often use a conventional 100A meter base and analog meter as an<br>
independent metering system for inverter output.  These meters<br>
typically have a minimum conductor size of #6 AWG.  For smaller<br>
systems the inverter output conductors are smaller than #6 AWG.  We<br>
have upsized the conductors to match the meter base requirement, but<br>
this adds expense.  I am looking for other suggestions for resolving<br>
this.<br>
<br>
With Regards<br>
Carl Adams<br>
SunRock Solar<br>
_______________________________________________<br>
List sponsored by Home Power magazine<br>
<br>
List Address: <a href="mailto:RE-wrenches@lists.re-wrenches.org">RE-wrenches@lists.re-wrenches.org</a><br>
<br>
Options & settings:<br>
<a href="http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org" target="_blank">http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org</a><br>
<br>
List-Archive: <a href="http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org" target="_blank">http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org</a><br>
<br>
List rules & etiquette:<br>
<a href="http://www.re-wrenches.org/etiquette.htm" target="_blank">www.re-wrenches.org/etiquette.htm</a><br>
<br>
Check out participant bios:<br>
<a href="http://www.members.re-wrenches.org" target="_blank">www.members.re-wrenches.org</a><br>
<br>
</blockquote></div><br>