<font face="arial" size="4">Thanks everyone for the feedback on my question!<br><br>Todd<br><br>On Friday, October 1, 2010 9:32am, "Larry Crutcher" <larry@starlightsolar.com> said:<br><br>> Todd,<br>> <br>> The shunt is only providing a mV DC signal. In our showroom we have a<br>> working display wall of charge controllers and battery monitors (Blue<br>> Sky, Trimetric, Morningstar, analog meters) with a single shunt to a<br>> single battery. Works well for us. More than likely there is isolation<br>> before the AD converter so I would not expect any problems with any<br>> monitor.<br>> <br>> Prescaler may be a different story although I suspect it will work. It<br>> is just converting a high voltage reference to a low one that the<br>> battery monitor can accept. If there was an issue I would try a small<br>> DC-DC device at the prescaler outputs going to each monitor.<br>> <br>> Larry Crutcher<br>> Starlight Solar Power Systems<br>> <br>> On Oct 1, 2010, at 2:22 AM, Todd Cory wrote:<br>> <br>> > Has anyone ever paralleled two amp hour meters on one shunt? How<br>> > about paralleling two e-meters on a single shunt and a single<br>> > prescaler?<br>> ><br>> > Todd<br>> <br>> _______________________________________________<br>> List sponsored by Home Power magazine<br>> <br>> List Address: RE-wrenches@lists.re-wrenches.org<br>> <br>> Options & settings:<br>> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org<br>> <br>> List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org<br>> <br>> List rules & etiquette:<br>> www.re-wrenches.org/etiquette.htm<br>> <br>> Check out participant bios:<br>> www.members.re-wrenches.org<br>> <br>> <br></font><br><br><br>Sent from Finest Planet WebMail.<br>