<div>I have a customer with a link 10 meter that keeps resetting and flashing.</div>
<div>The wires are tight on both ends and i have not been able to get it to reset while I am on site. </div>
<div> </div>
<div>It runs throught a 2 amp fuse that has not blown and it gets it's main power from the battery side of the main breaker.</div>
<div>The battery bank is large so sudden voltage swings are not the problem.</div>
<div>The meter is 1.5 years old and has done this from initial install. The owner did not know it was unusual....</div>
<div> </div>
<div>The voltage on the meter agrees with the battery voltage in the power building so i don't think it is a case of voltage drop.</div>
<div> </div>
<div>I am taking a 3 hour drive Saturday and would like to figure it out.</div>
<div> </div>
<div> I have installed a few dozen of these and have never had one reset unless it had it's power disconnected and if it's doing that, i can't catch it.</div>
<div> </div>
<div>Anyone got any ideas?</div>
<div> </div>
<div>Thanks,</div>
<div>Bob</div>