<div>I wonder if the caulk could have been removed with a sharp razor blade without hurting the coating?</div>
<div> </div>
<div>Bob<br><br></div>
<div class="gmail_quote">On Mon, Nov 24, 2008 at 8:18 AM, Tom DeBates <span dir="ltr"><<a href="mailto:habitek83@yahoo.com">habitek83@yahoo.com</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="PADDING-LEFT: 1ex; MARGIN: 0px 0px 0px 0.8ex; BORDER-LEFT: #ccc 1px solid">
<table cellspacing="0" cellpadding="0" border="0">
<tbody>
<tr>
<td valign="top">good day Wrenches,<br>  I've had a list of questions to pose. Please excuse me if these have been addressed previously.<br><br>1. What are your thoughts on using dielectric grease on terminal connections?....especially on exterior connections, even if those connections are in a weather-tite enclosure.<br>
<br>2. What are you using for a torque setting for 1/4-20 module clamp bolts? Seems most manufacturers spec 15 ft.-lbs. We have found this to be too high (especially with t-bolts) and are using ~ 140 in.-lbs.<br><br>3. A tip on module glass: We recently had some Evergreen 170's stored on a roof (flat) for a project (uncovered!). The roofers decided that they would make a good workbench and when we went to install there was some caulk (urethane?) on the face of one of them. After trying to remove the caulk with a wood shim, I tried using mineral spirits which, of course, was totally ineffective. The roofers happened to have some acetone on-hand which I borrowed and removed the caulk...big mistake. After installation, it was obvious that there was a module with "smudges" that we could not wash-off. I contacted Evergreen about this but was unable to receive an answer to my question as to whether-or-not the acetone had etched or removed the anti-reflection coating. I think that it did. We replaced the module.<br>
<br>thanks,<br>Tom <br><br>Tom DeBates<br>Habi-Tek<br>524 Summit St.<br>Geneva,IL. 60134<br>630-262-8193<br>fax 630-262-1343</td></tr></tbody></table><br><br>_______________________________________________<br>List sponsored by Home Power magazine<br>
<br>List Address: <a href="mailto:RE-wrenches@lists.re-wrenches.org">RE-wrenches@lists.re-wrenches.org</a><br><br>Options & settings:<br><a href="http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org" target="_blank">http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org</a><br>
<br>List-Archive: <a href="http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org" target="_blank">http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org</a><br><br>List rules & etiquette:<br><a href="http://www.re-wrenches.org/etiquette.htm" target="_blank">www.re-wrenches.org/etiquette.htm</a><br>
<br>Check out participant bios:<br><a href="http://www.members.re-wrenches.org/" target="_blank">www.members.re-wrenches.org</a><br><br><br></blockquote></div><br>