<table cellspacing="0" cellpadding="0" border="0" ><tr><td valign="top" style="font: inherit;">good day Wrenches,<br>  I've had a list of questions to pose. Please excuse me if these have been addressed previously.<br><br>1. What are your thoughts on using dielectric grease on terminal connections?....especially on exterior connections, even if those connections are in a weather-tite enclosure.<br><br>2. What are you using for a torque setting for 1/4-20 module clamp bolts? Seems most manufacturers spec 15 ft.-lbs. We have found this to be too high (especially with t-bolts) and are using ~ 140 in.-lbs.<br><br>3. A tip on module glass: We recently had some Evergreen 170's stored on a roof (flat) for a project (uncovered!). The roofers decided that they would make a good workbench and when we went to install there was some caulk (urethane?) on the face of one of them. After trying to remove the caulk with a wood shim, I tried using mineral spirits
 which, of course, was totally ineffective. The roofers happened to have some acetone on-hand which I borrowed and removed the caulk...big mistake. After installation, it was obvious that there was a module with "smudges" that we could not wash-off. I contacted Evergreen about this but was unable to receive an answer to my question as to whether-or-not the acetone had etched or removed the anti-reflection coating. I think that it did. We replaced the module.<br><br>thanks,<br>Tom <br><br>Tom DeBates<br>
Habi-Tek<br>
524 Summit St.<br>
Geneva,IL. 60134<br>
    630-262-8193<br>
fax 630-262-1343</td></tr></table><br>