Hi Daryl,

Could you please direct us to the code article that gives the requirement of 1.5
threads per inch?

Thanks,
Dick Ratico
Solarwind Electric
P.O.Box 402
Bradford, VT 05033
702-222-9028 

--- You wrote:
I think the code requirement is 1.5 threads in the
material.  A 24 tpi would be fine for all the frames I
am familiar with.  The 24 thread if at least 1.5
threads are in the material is stronger than the 32
tpi due to greater thread depth.
--- end of quote ---

- - - -
To send a message: RE-wrenches@topica.com

Archive of previous messages: http://www.topica.com/lists/RE-wrenches/

List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm

Check out participant bios: www.mrsharkey.com/wrenches/index.html

Hosted by Home Power magazine

Moderator: michael.welch@homepower.com
==^================================================================
This email was sent to: michael_welch@sbcglobal.net

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe@topica.com

TOPICA - Start your own email discussion group. FREE!
http://www.topica.com/partner/tag02/create/index2.html
==^================================================================


