[RE-wrenches] Considerations for steep roof installation
William Miller
william at millersolar.com
Wed May 20 09:07:14 PDT 2026
Tyrone:
I have some experience with steep roofs. To keep this post short I will
start with two recommendations:
Scaffold the eaves. This gives you a place to stage materials and to rest
your calves. It is a last resort back-stop if you take a slide.
Fall protection harness with positioning d-rings. These are two rings at
your hips that you can clip in a bridle you can lean back against.
Good luck.
William Miller
Miller Solar.com
805-438-5600
www.millersolar.com
On Wed, May 20, 2026 at 8:31 AM Tyrone Houck via RE-wrenches <
re-wrenches at lists.re-wrenches.org> wrote:
> Greetings wrenches,
> I am looking at a job with an extreme pitch comp roof(60°) and figured I
> would reach out to see what other installers' experiences have been and
> what recommendations or best practices advice ones might have. It's rare
> that we do anything steeper than 45° so I would greatly appreciate any
> insight you guys may have!
> Sunny Regards,
>
> Tyrone Houck
> Oregon Solarworks LLC
> CCB #204937 LRT #076
> 541-787-1366
> tyrone at oregonsolarworks.com
>
>
>
>
>
>
> _______________________________________________
> List sponsored by Redwood Alliance
>
> Pay optional member dues here: http://re-wrenches.org
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> There are two list archives for searching. When one doesn't work, try the
> other:
> https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
>
> List rules & etiquette:
> http://www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> http://www.members.re-wrenches.org
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org/attachments/20260520/e705e884/attachment.htm>
More information about the RE-wrenches
mailing list