[RE-wrenches] Xantrex XW6048 HOT!
Jason Szumlanski
jason at floridasolardesigngroup.com
Thu Jun 13 14:27:18 PDT 2024
It has a Combox and I was able to check the system using the web interface
on the local network. There were no faults at the time I was there, but
there was an OverTemp warning. I have not personally observed it with the
F66 error, so I don't know anything else, but it stands to reason that
eventually the warning reaches the level of a fault/error. I'm going to see
what happens with the Inverter and Charger functions disabled. If it faults
out again, I will just delete it from the system.
Thanks, everyone, for the help. I'll report back if I learn anything else.
Jason Szumlanski
Principal Solar Designer | Florida Solar Design Group
NABCEP Certified Solar Professional (PVIP)
Florida State Certified Solar Contractor CVC56956
Florida Certified Electrical Contractor EC13013208
On Thu, Jun 13, 2024 at 11:41 AM Dave Angelini Offgrid Solar via
RE-wrenches <re-wrenches at lists.re-wrenches.org> wrote:
> Going out the door.
>
> If the bad inverter is the master. You will need to assign a new master.
> Since this is 1st generation XW you will need to use SCP and probably use
> the manual if you are not familiar. Rebuild the xanbus network.
>
> That is alot of loading and the usual warnings about heat killing
> electronics and the need of cooling down your way. Good Luck!
>
>
>
>
> *Dave Angelini Offgrid Solar
> "we go where powerlines don't"
> <http://members.sti.net/offgridsolar/>https://offgridsolar1.com/ <https://offgridsolar1.com/> <http://members.sti.net/offgridsolar/>
> e-mail offgridsolar at sti.net <offgridsolar at sti.net>
> text 209 813 0060*
>
>
> On 2024-06-13 8:26 am, Dave Angelini Offgrid Solar via RE-wrenches wrote:
>
> Disco 250A breaker on bad XW and remove its xanbus RJ45. Assume the bad
> one is not the master?
>
>
>
> *Dave Angelini Offgrid Solar
> "we go where powerlines don't"
> <http://members.sti.net/offgridsolar/>https://offgridsolar1.com/ <https://offgridsolar1.com/> <http://members.sti.net/offgridsolar/>
> e-mail offgridsolar at sti.net <offgridsolar at sti.net>
> text 209 813 0060*
>
>
> On 2024-06-13 8:01 am, Jason Szumlanski via RE-wrenches wrote:
>
> I'm looking at an off-grid quad inverter setup for a client, not my
> installation. One of the stacked.inverters is extremely hot, sometimes it
> goes into F66 and takes down the adjacent inverters with it to F66 probably
> because of these Xanbus network is broken.
>
> I disabled charging and discharging on the inverter that is getting hot,
> but it's still remains very hot. Any ideas?
>
> I tried to put that one inverter in standby, but the generator will not
> sync with the remaining three and charge the batteries. So I have to leave
> it in normal operating mode for the moment.
>
> Jason Szumlanski
> Florida Solar Design Group
>
> _______________________________________________
> List sponsored by Redwood Alliance
>
> Pay optional member dues here: http://re-wrenches.org
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> There are two list archives for searching. When one doesn't work, try the
> other:
> https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
>
> List rules & etiquette:
> http://www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> http://www.members.re-wrenches.org
>
>
> _______________________________________________
> List sponsored by Redwood Alliance
>
> Pay optional member dues here: http://re-wrenches.org
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> There are two list archives for searching. When one doesn't work, try the
> other:
> https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
>
> List rules & etiquette:
> http://www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> http://www.members.re-wrenches.org
>
> _______________________________________________
> List sponsored by Redwood Alliance
>
> Pay optional member dues here: http://re-wrenches.org
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> There are two list archives for searching. When one doesn't work, try the
> other:
> https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
>
> List rules & etiquette:
> http://www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> http://www.members.re-wrenches.org
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org/attachments/20240613/4f0e95f8/attachment.htm>
More information about the RE-wrenches
mailing list