[RE-wrenches] XW EQ question

[Kevin Pegg]

I have seen the same behaviour on a few older XW6048's as well - including my own. It will go into EQ mode after completion of Absorb charge, but voltage does not increase as programmed. Adjusting the absorb settings manually is a clumsy workaround. I assumed it's a software bug. 

Kevin

-----Original Message-----
From: RE-wrenches <re-wrenches-bounces at lists.re-wrenches.org> On Behalf Of jay via RE-wrenches
Sent: February-12-24 11:36 AM
To: RE-wrenches <re-wrenches at lists.re-wrenches.org>
Cc: jay <jay.peltz at gmail.com>
Subject: [RE-wrenches] XW EQ question

HI All,

I have a client with an older XW 6048 with 2 x XW-60 controllers, SCP etc.

He can’t seem to get the EQ to work with either equipment.

Its set to 62.4v for Rolls flooded batteries, but it won’t go above 60v.

It is charging normally to just at 60v so its not a temp sensor failure.

Any thoughts?

thanks

jay


_______________________________________________
List sponsored by Redwood Alliance

Pay optional member dues here: http://re-wrenches.org

List Address: RE-wrenches at lists.re-wrenches.org

Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org

There are two list archives for searching. When one doesn't work, try the other:
https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/
http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org

List rules & etiquette:
http://www.re-wrenches.org/etiquette.htm

Check out or update participant bios:
http://www.members.re-wrenches.org