[RE-wrenches] Over voltage error message
Drake
drake.chamberlin at redwoodalliance.org
Fri Jul 21 06:48:47 PDT 2017
Hello boB and Steve,
I haven't been able to make it to the site yet, but so far, no more
reports of spikes. I plan to try boB's suggestion of shutting off the
grid input while it is selling, to see what happens.
The spike did only last one second, so I don't think it is a chemical
whip effect. If the spike only lasted a fraction of a second,
wouldn't the Mate 3 still show the event lasting a second, since that
is its lowest level of granularity?
The array size is 2240 W and the Concorde battery bank is 305 AH at
48 V for a C/6.5 charge rate. The battery bank should have been
fully charged. If the grid went down and the Radian quit selling
during a heavy selling period, could that not cause a 1 second
voltage spike, or should the Classic catch it instantaneously?
Thanks,
Drake
At 11:49 PM 7/18/2017, bob at midnitesolar.com wrote:
>The Classic can overshoot but not very much, normally.
>
>I would try this...
>
>Sell to grid while watching the battery voltage and then turn the
>inverter breaker off
>
>and see what the battery voltage does. If the battery voltage rises
>to the mid 60V range
>
>from a low sell voltage of around 52 or 53V, then something is really amiss.
>
>If the system has been in service for some time, you might also
>check the capacity of
>
>the batteries. They should not easily allow 65-ish volts. I don't
>think that the
>
>FM's communication can respond to keep spikes from happening any better
>
>than it could without communications. Data packets just don't come all that
>
>often.
>
>boB
>
>On 7/18/2017 5:25 PM, Jerry Shafer wrote:
>>Wrenches
>>The Outback system with grid connection would be programmed for
>>grid connection all the way from the inverter to the Outback FM CC,
>>using a midnite CC this option may not be possible resulting to a
>>CC push if the grid disconnects resulting in a spike. the
>>disconnect might be from settings to tight or as it was said
>>utility spikes. You might thing that the battery bank should take
>>it up but internal resistance in the battery or to it may prevent
>>it. The other thing I would look at is connections, if there is any
>>resistance in a connection this could happen.
>>
>>On Mon, Jul 17, 2017 at 2:36 AM, Drake
>><<mailto:drake.chamberlin at redwoodalliance.org>drake.chamberlin at redwoodalliance.org>
>>wrote:
>>Hello Wrenches,
>>
>>My client reported seeing an overvoltage error message on her Mate
>>3 on a Radian system. The Radian is selling to the grid and is
>>being fed by a Midnite Classic 200. It has shown two spikes so far,
>>the last one going to 67 volts and lasting 1 second. The batteries
>>are Concorde AGM, 305 AH.
>>
>>Does this momentary spike seem like a problem or a warning of
>>problems to come?
>>
>>Thanks,
>>
>>Drake
>>
>>_______________________________________________
>>List sponsored by Redwood Alliance
>>
>>List Address:
>><mailto:RE-wrenches at lists.re-wrenches.org>RE-wrenches at lists.re-wrenches.org
>>
>>Change listserver email address & settings:
>><http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org>http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>>
>>List-Archive:
>><http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html>http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
>>
>>List rules & etiquette:
>><http://www.re-wrenches.org/etiquette.htm>www.re-wrenches.org/etiquette.htm
>>
>>Check out or update participant bios:
>><http://www.members.re-wrenches.org>www.members.re-wrenches.org
>>
>>
>>
>>
>>
>>_______________________________________________
>>List sponsored by Redwood Alliance
>>
>>List Address:
>><mailto:RE-wrenches at lists.re-wrenches.org>RE-wrenches at lists.re-wrenches.org
>>
>>Change listserver email address & settings:
>><http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org>http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>>
>>List-Archive:
>><http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html>http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
>>
>>List rules & etiquette:
>><http://www.re-wrenches.org/etiquette.htm>www.re-wrenches.org/etiquette.htm
>>
>>Check out or update participant bios:
>><http://www.members.re-wrenches.org>www.members.re-wrenches.org
>>
>
>_______________________________________________
>List sponsored by Redwood Alliance
>
>List Address: RE-wrenches at lists.re-wrenches.org
>
>Change listserver email address & settings:
>http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
>List-Archive:
>http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
>
>List rules & etiquette:
>www.re-wrenches.org/etiquette.htm
>
>Check out or update participant bios:
>www.members.re-wrenches.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org/attachments/20170721/10c93d53/attachment-0003.html>
More information about the RE-wrenches
mailing list