[RE-wrenches] Enphase failures

holtek at sbcglobal.net holtek at sbcglobal.net
Sat Jul 14 07:07:11 PDT 2012


350+ installed, 5 replacements over a 2 year period (.02%). 1-190, 4-215, 
0-210 (we use Sanyo on many residential systems)

accessibility built in to design is also a plus - not always possible, but 
should be a factor when doing layouts.

Holt E. Kelly
Holtek Fireplace & Solar Products
500 Jewell Dr.
Waco TX. 76712
254-751-9111
www.holteksolar.com

----- Original Message ----- 
From: "William Miller" <william at millersolar.com>
To: "RE-wrenches" <re-wrenches at lists.re-wrenches.org>
Sent: Saturday, July 14, 2012 12:49 AM
Subject: Re: [RE-wrenches] Enphase failures


> Troy:
>
> Of the 100 or so Enphase inverters we have seen 2 fail.  I have my fingers 
> crossed.
>
> Wm
>
> PS:
>
> Xantrex GT:  About 15% failure
> SMA SB:  About 15% failure
> Fronius:  300% failure rate
>
> wm
>
>
> At 01:02 PM 7/5/2012, Troy Harvey wrote:
>>I'm wondering how many of you have had Enphase failures in the field. 
>>Basically every one of our sites with M175 or M190 has seen failures. Most 
>>of those are one their second wave of replacements. It appears these have 
>>a linear failure rate in the field, and we have to replace 2 to 3 
>>inverters at every site, every year.
>>
>>At this point we have stopped using Enphase products because the cost of 
>>replacement is too high. You have to disassemble a whole array just to 
>>replace 1 or 2 inverters. In theory it gives you per-panel diagnostics, 
>>but that is just silly considering the panels are thousands of times more 
>>durable than the inverters.
>>
>>What is your experience?
>>
>>thanks,
>>
>>Troy Harvey
>
> _______________________________________________
> List sponsored by Home Power magazine
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Options & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> List-Archive: 
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
>
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
>
> Check out participant bios:
> www.members.re-wrenches.org
> 




More information about the RE-wrenches mailing list