[RE-wrenches] 90 degree wire bends
Darryl Thayer
daryl_solar at yahoo.com
Wed Nov 16 20:01:08 PST 2011
I have seen the lightening damage at tight bends, but in my electrical career of 60+ years I have not seen any other
problems.
Darryl
________________________________
From: Ray Walters <ray at solarray.com>
To: RE-wrenches <re-wrenches at lists.re-wrenches.org>
Sent: Wednesday, November 16, 2011 12:11 PM
Subject: Re: [RE-wrenches] 90 degree wire bends
It seems that if the strands were stretched and therefore thinned, that that would increase resistance, some. I think more importantly, the insulation bunchs up and cracks, and is definitely compromised. Also with strain hardening of copper, I'm sure some strands could break internally with a tight enough bend. I've heard at least for bare ground wires that lightning will jump off to the case at tight bends, but I've never actually seen that.
Aside from all that, is there actually an increased impedance from a
tight bend (like in plumbing)? I don't know.
I've had to stop more than one journeyman from violating 300.34. I
just tell them the bends should look like the long sweeps in conduit
relative to the diameter of the wire: also purdy.
Aloha,
Ray
On 11/16/2011 10:35 AM, Marco Mangelsdorf wrote:
>Some electricians have great fun in making 90 degree wire bends to try and make their enclosure wiring look so purdy.
>
>Given the importance of maintaining wiring radiuses, this can’t be a good idea, can it? Is the issue greater resistance when the wire is bent at a straight 90 degrees (or more)?
>
>Thanks,
>marco
>
>
>
>_______________________________________________
List sponsored by Home Power magazine List Address: RE-wrenches at lists.re-wrenches.org Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches at lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org/attachments/20111116/289011ba/attachment-0003.html>
More information about the RE-wrenches
mailing list