[RE-wrenches] generator surge on outback system
Steve Higgins
shiggins at outbackpower.com
Thu Aug 12 11:43:54 PDT 2010
Kirk
I am currently in Namibia, so email or phone calls are a bit of a
pain... I have asked Sandra In tech support to call you and help you
with this if that ok with you?
Steve Higgins
Sr Application Engineering Mgr
Sub-Saharan Africa Business Dev Mgr.
Direct: 360-618-4314
OutBack Power Technologies
19009 62nd Ave NE, Arlington, WA 98223 USA
Tel: 360.435.6030 Fax: 360.435.6019
www.outbackpower.com
From: re-wrenches-bounces at lists.re-wrenches.org
[mailto:re-wrenches-bounces at lists.re-wrenches.org] On Behalf Of Jeff
Oldham
Sent: Thursday, August 12, 2010 10:26 AM
To: re-wrenches at lists.re-wrenches.org
Subject: Re: [RE-wrenches] generator surge on outback system
The Cool Down program does disconnect the genset from the inverter (xfer
& charger) for the cool down cycle. This likely will solve your issue.
If the genset was not disconnected the it would remain loaded and there
would not be a cool down. The whole point of cool down is to have the
loads removed so the turbo can cool slowly to mitigate and deformity. In
most modern machines this is generally no longer an issue, but again it
should solve your surge.
-jeff o
>From the Solar, Wind and Hydro powered office of Jeff
Oldham/Regenerative SOLutions
____________________________________________________________
Get Free Email with Video Mail & Video Chat!
<http://www.juno.com/freeemail?refcd=JUTAGOUT1FREM0210>
MESSAGE CONFIDENTIALITY NOTICE:
This message (including attachments) is covered by the Electronic Communication Privacy Act, 18 U.S.C. sections 2510-2521, is confidential, and may also be protected by attorney-client or other privilege. If you believe that it has been sent to you in error, please do not read it. If you are not the intended recipient,you are hereby notified that any retention, dissemination, distribution, or copying of this communication is strictly prohibited. Please reply to the sender that you have received the message in error, then delete it. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org/attachments/20100812/5d2b4efc/attachment-0004.html>
More information about the RE-wrenches
mailing list