[RE-wrenches] AC coupling

[Christopher Freitas]

I should have also mentioned that the "dump" or "diversion" control  can
be done via an AC load with a relatively inexpensive AC solid-state
relay and AC loads such as AC baseboard or AC electric water heater
elements - which are much easier and less expensive than doing it with
the lower voltage / higher current DC relay and loads.  

 

The OutBack FX series offers an AUX output control mode for both AC and
DC diversion which has a fixed voltage level but has an adjustable "on"
time which can be set to zero for applications using a solid-state
relay.   

 

Christopher

 


MESSAGE CONFIDENTIALITY NOTICE:
This message (including attachments) is covered by the Electronic Communication Privacy Act, 18 U.S.C. sections 2510-2521, is confidential, and may also be protected by attorney-client or other privilege. If you believe that it has been sent to you in error, please do not read it. If you are not the intended recipient,you are hereby notified that any retention, dissemination, distribution, or copying of this communication is strictly prohibited.  Please reply to the sender that you have received the message in error, then delete it. Thank you.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org/attachments/20081105/214a12b4/attachment-0003.html>