homework [RE-wrenches]
Mark Frye
markf at berkeleysolar.com
Sun Apr 13 14:19:08 PDT 2008
William,
Thanks,
I see your azimuth calc validates mine.
However, module tilt is also effected, so I guess you have to set up another
drawing to draw the actual module tilt.
Mark Frye
Berkeley Solar Electric Systems
271 Vistamont Dr
Grass Valley CA 95945
(530) 401-8024
www.berkeleysolar.com
-----Original Message-----
From: William Miller [mailto:wrmiller at charter.net]
Sent: Saturday, April 12, 2008 11:28 PM
To: RE-wrenches at topica.com
Subject: Re: homework [RE-wrenches]
Max:
I guess you miss my point: Why tilt the panels up and incur aesthetic,
structural and geometric headaches when there is so little to gain by doing
so in a grid-tie system?
Or, maybe I miss your point: Try this logic: If the roof slopes to 296 T
and your rows are flat on the roof, the azimuth of your modules is 296. If
the row is tilted up to vertical (even if it is running down the pitch)
your orientation is 206. The azimuth sweeps between the two orientations
depending on the tilt. My 3d cad shows the azimuth of the panels as 81 deg
west of south (261). This is the orientation of the modules when viewed
from overhead, ignoring tilt.
Or, you are not explaining your question in a manner that I understand....
William Miller
- - - -
Hosted by Home Power magazine
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at re-wrenches.org
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
More information about the RE-wrenches
mailing list