Sanyo panel short MC wires [RE-wrenches]

Blair May tump at hughes.net
Fri Feb 1 16:54:07 PST 2008


Drill ye tarriers drill. We will usually drill holes in the rail BUT DP&W does have a clip that fits into the rail alowing u 2 secure the wires as does Shuco co. 

Sent via BlackBerry by AT&T



-----Original Message-----

From: troy <taharvey at heliocentric.org>



Date: Fri, 1 Feb 2008 16:42:36 

To:RE-wrenches at topica.com

Subject: Sanyo panel short MC wires [RE-wrenches]







I'm mounting Sanyo HIP panels horizontally on Horizontal roof rails  

(unirac sunframe). I found that Sanyo panels do not have enough wire  

length to be pulled to the side rails and tied down. There is just  

enough wire to connect the panels plus a couple of inches. The panels  

do not have a curl under frame, so there aren't any mounting locations  

on panels to place a clip or strain relief.  I have not found a  

reasonable solution other than to let the MCs dangle down onto the  

roof - which makes me uncomfortable, not what I feel is "best practice".



Has anyone else dealt with this? Has anyone seen issues with MCs  

rubbing on rooftops due to wind or ice issues that has caused issues  

over time.







Troy Harvey

---------------------

Heliocentric

801-453-9434

taharvey at heliocentric.org





- - - -

Hosted by Home Power magazine



To send a message: RE-wrenches at topica.com



Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read



List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php



Check out participant bios: www.mrsharkey.com/wrenches/



Moderator: michael.welch at homepower.com





- - - -
Hosted by Home Power magazine

To send a message: RE-wrenches at topica.com

Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read

List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php

Check out participant bios: www.mrsharkey.com/wrenches/

Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at re-wrenches.org

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com

For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------





More information about the RE-wrenches mailing list