Battery Fuel Gauge [RE-wrenches]
Joel Davidson
joeldavidson at earthlink.net
Wed Nov 8 20:01:40 PST 2006
<x-flowed>
Don,
Menu #11 AC Inputs sets the lowest voltage at which the inverter is allowed
to be connected to the utility grid (AC Input 1) or to the generator (AC
Input 2). The range is 85 to 110 VAC. If grid or genset voltage drops below
the setpoint, the inverter will disconnect from the grid or genset and power
the load from the battery. My dilemma is if I lower the setting from the
default 108 VAC, then I will not get nuisance grid brownout switch-overs to
the inverter off-grid mode, but the low grid voltage will not power some
loads and will shorten the load life. On the other hand, if I raise the
setting to 110 VAC, then I will get more brownout switch-overs from grid to
battery but my small battery bank is only 3.3 kWh. So I complain to Southern
California Edison when the voltage drops below 110 VAC. If SCE does not
correct the low voltage (probably replace the old pole-mount transformer),
the next step is to complain to the CPUC.
Joel Davidson
----- Original Message -----
From: "Don Loweberg" <I2P at aol.com>
To: <RE-wrenches at topica.com>
Sent: Wednesday, November 08, 2006 7:16 PM
Subject: Re: Battery Fuel Gauge [RE-wrenches]
>
>
> In a message dated 11/7/2006 6:38:54 PM Pacific Standard Time,
> joeldavidson at earthlink.net writes:
> What is your SW5548 menu setting for #11 AC Inputs > Set input low limit
> VAC?
>
>
>
> I think when these inverters are in "sell" mode you can not adjust the low
> ac
> limit. Rather it is determined and fixed by the net metering required
> window
> on voltage. +_ 10%
>
> Don
>
> [Non-text portions of this message have been removed]
>
>
> - - - -
> To send a message: RE-wrenches at topica.com
>
> Archive of previous messages:
> http://lists.topica.com/lists/RE-wrenches/read
>
> List rules & how to change your email address:
> www.mrsharkey.com/wrenches/etiquette.php
>
> Check out participant bios: www.mrsharkey.com/wrenches/
>
> Hosted by Home Power magazine
>
> Moderator: michael.welch at homepower.com
>
>
>
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
</x-flowed>
More information about the RE-wrenches
mailing list