IR Gun (was Favorite tool) [RE-wrenches]
Phil Undercuffler
p.undercuffler at conergy.us
Thu May 11 13:14:36 PDT 2006
Uhhh, the disposable kind? ;-)
Seriously though, do you need a quick, one-time measurement, or are you
looking to create a permanent spot to allow measurements over time?
If the first, a bit of electricians tape will probably survive long enough
to get a reading. If the second, I'd look for some of that epoxy muffler
mending tape sold in automotive stores. Remember, you're not trying to mend
the pipe, just give a non-reflective surface.
Please note new phone extensions
---------------------------------------------------------
Phil Undercuffler
Technical Service Manger, ext. 0741
Conergy, Inc.
1730 Camino Carlos Rey Suite 103
Santa Fe NM 87507 USA
Tel 505-473-3800 ext 0741
Fax 505-473-2134
www.conergy.us
---------------------------------------------------------
-----Original Message-----
From: Bill Loesch, Saint Louis Solar [mailto:bill_loesch at compuserve.com]
Any suggestion for a "tape" on a polished stainless exhaust pipe that
approaches 500 oF?
Bill Loesch
Solar 1- Saint Louis Solar
314 631 1094
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
More information about the RE-wrenches
mailing list