Outback FX and Generator Input [RE-wrenches]

[David Palumbo, Independent Power & Light]

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Erase wrinkles without Botox! Nexiderm SP is clinically proven to 
reduce wrinkles by 68% Click here to get your 30-day free supply.
http://click.topica.com/caadOvzbz8Qcsbz9JC9a/Nexiderm
-------------------------------------------------------------------

DT,
Very interesting solution. I am curious as to what the efficiency of this
setup vs. the usual Gen to FX to Batteries setup.

DP


<<Jeremy
I had a similar problem, where on the system supplied
most of the energy, but the generator was needed
rarely.  The gen just did not perform.  SO I took an
auto transformer and connected to the generator to
reduce the voltage to 50% and then placed into
full-wave rectfier and hooked the output to an MX60.
The MX 60 was set to limit the output current.  It did
not matter what the frequency of the generator or
voltage was, the MX60 takes the DC and charges the
battery.  I used it on a 48 volt system.

Please note I did not have Outback approval, but the
system is about 2 years old and no problems.

DT>>

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Get up to $1500.00 Fast and Easy!
No Credit Checks! No Paper Hassles! Nothing To Fax!
Apply Online and We'll Contact You Within the Hour!
http://click.topica.com/caadOuobz8Qcsbz9JC9f/911PaydayAdvance
-------------------------------------------------------------------

- - - -
To send a message: RE-wrenches at topica.com

Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read

List rules & etiquette: www.mrsharkey.com/wrenches/etiquette.php

Check out participant bios: www.mrsharkey.com/wrenches/

Hosted by Home Power magazine

Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com

For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------