L-16 "cycling" requirements? [RE-wrenches]

[Bob Ellison]

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Get a Free T-Mobile Sidekick II plus $500 towards service! 
Click here.
http://click.topica.com/caaduFNbz8Qcsbz9JC9a/ProductTestPanel
-------------------------------------------------------------------

That was a long time ago then I was working on some C+D type single
cells (memory?) those you could get to the bottom to get a reading, hard
to do with any other cells. 
The point about the electrolyte and plates would probably be correct but
the bubbling would stir that up just like it relieves the
stratification.

I have some single cells here, I will see if I can get a tube to the
bottom to see what I can get for readings without stirring them up.
 

Got to run,
Bob

-----Original Message-----
From: Joel Davidson [mailto:joeldavidson at earthlink.net] 
Sent: Monday, May 23, 2005 9:53 PM
To: RE-wrenches at topica.com
Subject: Re: L-16 "cycling" requirements? [RE-wrenches]

Hello Bob,
Electrolyte touching the plates can have a different specific gravity
than 
free flowing electrolyte. What readings did you get when you measured 
electrolyte at different levels in cells that were not been equalized?
Joel Davidson

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Get a Free Sirius Satellite Package, don't pass on this!
http://click.topica.com/caadwPhbz8Qcsbz9JC9f/ProductTestPanel
-------------------------------------------------------------------

- - - -
To send a message: RE-wrenches at topica.com

Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read

List rules & etiquette: www.mrsharkey.com/wrenches/etiquette.php

Check out participant bios: www.mrsharkey.com/wrenches/

Hosted by Home Power magazine

Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com

For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------