Hydrocaps for IBE cells [RE-wrenches]
Gary Higbee
gary at windstreamsolar.com
Fri Feb 20 15:25:58 PST 2004
Wrenches,
I'm working with a client (on a system I did not install) who has Water
Miser caps on the IBE metal-clad 2-volt cells (I think around 1300Ah). We're
seeing a lot of water loss (and pooling on top of the cells). I'm wondering
if Hydrocaps are an idea or if this (only) 5-year old bank is about done
for.
I spoke with the folks who make the caps, and was sent a sheet with a bunch
of details to provide so they could be made. I would think there'd be a
standard part number for these, though.
Three questions:
1) The fact that we're seeing higher water loss and reduced battery capacity
suggests we're nearing the end of the life of these cells. Yes? Any
suggestions to hang in there a bit longer? The cells were not equalized for
several years, though the client is now doing so.
2) Regardless, have any of you used Hydrocaps on IBE cells? Where did you
get them?
3) Comments?
Thank you!
Gary
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~ Windstream Solar ~
Gary Higbee (gary at windstreamsolar.com)
(541 ) 607-1818 (Eugene)
(541) 954-3881 (Cell)
Solar, wind, and hydro site analysis and system design
Components dealer and installation assistance
Energy Trust of Oregon contracted system inspector
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://www.topica.com/lists/RE-wrenches/
List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm
Check out participant bios: www.mrsharkey.com/wrenches/index.html
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
TOPICA - Start your own email discussion group. FREE!
http://www.topica.com/partner/tag02/create/index2.html
--^----------------------------------------------------------------
More information about the RE-wrenches
mailing list