SB304- SB50 limits [RE-wrenches]

[Rick Cullen - RV Power Products]

So this is what it's like to be in the hot seat. At least it's not because
the product doesn't work...

I have had numerous conversations with individuals at Outback. They  have
designed their DC disconnect box to accept 4 or 5 SB3048/50's using standard
straight 1" feed throughs. I believe however that the units do not attach to
the back wall but are held in place by the feed throughs.

Thanks for all the on list and off list feedback.

Rick Cullen
RV Power Products, Inc.
Providing quality MPPT solar charge controllers
Phone 760-944-8882
Fax 760-634-8193

mail to: rick at rvpowerproducts.com
www.rvpowerproducts.com


----- Original Message -----
From: <sunwise at cheqnet.net>
To: <RE-wrenches at topica.com>
Sent: Tuesday, November 13, 2001 12:26 AM
Subject: Re: SB304- SB50 limits [RE-wrenches]


> Bob-O Schultze, Electron Connection wrote:
> >
> please put the 1" instead of the 1/2" KOs closest to the back of the
> controller.
> > bob-O
> >
> Yup, I'd ask for more KO options in general.  Why only half inch and one
> inch?  3/4 and bigger??  I've used 3/4 inch liquid tight and bushings on
> the RV end on the last couple SB50's I installed.  The L.T. gives you
> that little bit of flexibilty to off-set things.
>
> Speaking of off-sets and knock-outs, why isn't the outside edge of all
> holes, perhaps measured from the back of the box, standarized and in
> uniform paterns?  Could RV take a good look at the DC250 and Outbacks DC
> version prior to modifing KO's.  A lot of time is spent in the install
> getting everything all lined up and hooked together, even before you get
> any wire out of the truck!
>
> PS - I came close to breaking a screwdriver on the 1/2 inch KO I took
> out yesterday.  I even had to holster the linesman's plyers and go get a
> carpenter's hammer.
>
> Kurt Nelson
>
> - - - -
> To send a message: RE-wrenches at topica.com
>
> Archive of previous messages: http://www.topica.com/lists/RE-wrenches/
>
> List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm
>
> Check out participant bios: www.mrsharkey.com/wrenches/index.html
>
> Hosted by Home Power magazine
>
> Moderator: michael.welch at homepower.com
>
>
>

- - - -
To send a message: RE-wrenches at topica.com

Archive of previous messages: http://www.topica.com/lists/RE-wrenches/

List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm

Check out participant bios: www.mrsharkey.com/wrenches/index.html

Hosted by Home Power magazine

Moderator: michael.welch at homepower.com

==^================================================================
This email was sent to: michael.welch at homepower.com

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9
Or send an email to: RE-wrenches-unsubscribe at topica.com

T O P I C A -- Register now to manage your mail!
http://www.topica.com/partner/tag02/register
==^================================================================